3Com 3C3FE575CT User Manual - page 22
22
C
HAPTER
4: S
ETUP
FOR
W
INDOWS
95
Troubleshooting
Windows 95
Installations
Symptom
Solution
Basic
troubleshooting,
applicable for all
problem
situations.
Inspect all cables and connections.
Check whether your PC Card if fully inserted into the slot.
Verify whether you have the latest BIOS for your system. If not, check
the Web site for your notebook and follow the BIOS upgrade
instructions.
Check for multiple installations of the PC Card.
Check whether your system’s PCMCIA or CardBus Controller is
installed and running properly:
Go to My Computer/Control Panel/System/Device Manager/PCMCIA
Card. Verify that the controller is present and shows no errors.
Open My Computer/Control Panel/PC Card to confirm that the
system recognizes your PC Card.
In My Computer/Control Panel/Network application, make sure that
you have the correct clients and protocols installed.
At installation,
Update Device
Driver window
does not appear.
The PC Card may have already been installed.
The PC Card may have been installed as “Other Devices” because of
a previous faulty installation.
PCMCIA may not be enabled on your system.
The LAN device is
not functional.
LED on the
connector or PC
Card is off or
mismatches the
real network
speed.
Use My Computer/Control Panel/System/Device Manager to inspect
the status of FE575C-3Com 10/100 LAN CardBus-Fast Ethernet.
If you see a red “X”, enable the PC Card by checking the appropriate
box under Properties.
If you see a yellow exclamation mark, click on the icon to see what
the conflict is. Verify that there are adequate system resources. Try to
free system resources (for example, disable the infrared port), then
remove and reinstall the PC Card.
Losing network
connection after
disconnecting or
changing the
media speed
This can occur when using NetWare servers and IPX/SPX protocol. It
happens when the frame type is selected automatically. A temporary
solution is to reboot after disconnecting and reconnecting the cable
in NetWare networks. The permanent solution is to use specific frame
types such as 802.2 or 802.3.
Need to force
speed and duplex
settings.
In most cases, the automatic settings work fine. However, if you to
need to force speed or duplex settings to match those of an attached
device:
1. Open My Computer/Control Panel/Network.
2. Double click the FE575C-3Com 10/100 LAN CardBus-Fast Ethernet.
3. Click the Advanced tab.
4. Select Network Link Selection and choose the correct speed.