3Com 3C3FE575CT User Manual - page 27
Setup Procedure
27
4 Select the Adapters tab.
The Select Network Adapter window displays.
5 Go to the section “Setup With No Networking Installed” in this chapter for
instructions if the message “networking is not installed” displays, .
6 Click Have Disk...
7 Insert the LAN Installation Disk in the floppy drive and click OK or insert the LAN
Installation CD into the CD-ROM drive (change the path to the drive, for example,
d:\) and click OK.
8 Select FE575C-3Com 10/100 LAN CardBus-Fast Ethernet when the Select OEM
Option window opens and click OK.
9 Accept the default settings in the network Settings window and click Continue.
10 Wait while the files are copied to your notebook.
The default settings work in most instances. However, you may specify network
link settings, auto polarity, and IRQ and I/O values. Please see the Working
Configurations directory on the Installation CD.
11 Click Close.
12 Enter your IP address if prompted and click OK.
13 Click Yes to the DHCP prompt, if the prompt displays.
14 Click Apply.
15 Click OK.
16 Remove the LAN Installation Disk from the floppy drive or the LAN Installation CD
from the CD-ROM drive when prompted to reboot the notebook and click Yes.
Installing with Softex
For OmniBook 4150, 900, and XE2 users, please read the following procedure before
installing the 3Com 10/100 LAN CardBus PC Card using Softex Card Executive.
1 Make sure the driver diskette is removed from the notebook floppy drive.
2 Insert the 3Com 10/100 LAN CardBus PC Card into the PC Card slot.
Card Executive will attempt, but fail, to find the diskette.
3 When prompted, select Install driver provided with PC Card.
4 Type the following path and click OK:
a:\softex
The Network Settings window will display.
5 Select Continue.
The Protocol configuration window will display, depending on the protocol that
was chosen.
6 Reboot your system when prompted.
The PC Card is now installed.