3D Systems CUBE User Manual - page 110

106

3D Systems, Inc

.

4 .  Select the print jet you would like to purge and select the 

checkmark

 to continue .

5 .  Using the pliers from the tool kit, carefully pull down the material sleeve .

Caution: Do not pinch or twist the filament sleeve.

6 .  Using the pliers, grasp the print material just above the sleeve and push the 

material upward .

NOTE: Once the print jet begins to purge, the upward pressure will 

allow the feeder to engage the print material .

Caution: Exercise caution when handling the print material to 

ensure it does not break .

7 .  Continue to push the print material upward until the print jet begins purging .

NOTE: Once the print jet reached the operating temperature, it will 

begin to purge .

NOTE: After purging, the print jets will cool down .