3D Systems CUBE User Manual - page 114
Other manuals for CUBE:
User Manual, Quick Start Manual, Quick Start Manual, User Manual, User manual
Manual is about: Personal 3D Printer 3rd Generation
of
121
110
3D Systems, Inc
.
NOTE: The firmware will begin to install. The blue bar is a progress
indicator .
NOTE: The installation could take a few minutes .
WARNING: DO NOT POWER OFF OR DISCONNECT THE PRINTER
FROM UTILITY POWER DURING THE UPDATE PROCESS .
4 . When prompted, press and release the
power button
and wait until the display
turns on .
NOTE: It may take a minute for the display to turn on .
5 . Perform the Auto Level and Auto Gap procedures .
NOTE: For more information, refer to the section titled
Print Pad
Calibration
.