3D Systems CUBE User Manual - page 32

28

3D Systems, Inc

.

7

  PRINTING YOUR CREATION

There are many 3D creations available at www .cubify .com . In addition, you can create your own with Cubify Invent and Cubify Sculpt 

software available at www.cubify.com. The printer can only print .cube3 files. Other file formats like .stl must be processed through 

Cubify software before they can be printed .

For more information about converting other 3D files to .cube3 print files, refer to the section titled 

Cubify Software

 .

PRINTING PROCEDURE

The following procedure illustrates how to print a creation .

Caution: Ensure the print pad is clean before printing .

NOTE: For best results, perform the Auto Level and Auto Gap procedures before your first print.

NOTE: After every 10 prints, the printer will prompt you to perform the Auto Level and Auto Gap procedures . 

1 .  After powering on your printer, press the

 touchscreen

 to begin .

2 .  Select 

PRINT

 .

NOTE: If the file is saved on a USB mass storage device, insert the 

device into the USB inlet port on the printer .

NOTE: You may also send the file from Cubify software to the 

printer using a wireless connection. Wireless transfer of print files 

usually takes more time than USB mass storage device transfer .

3 .  Using the arrows, navigate to the file name of your creation. Select 

PRINT

 .

NOTE: The file name will appear at the top of the display.