3D Systems CubePro Repair Manual - page 11

10

3D Systems, Inc

.

3.  Using the designated page from the Setup/Repack instructions, slide the paper 

between the print jets and the print pad.

NOTE: If there is a slight resistance, proceed to step 5.

NOTE: The red line (C) illustrates the gap between the print jets (A) 

and the print pad (B).

4.  If the paper slides easily between the print jets and print pad, rotate the 

adjustment knob counter-clockwise (from the bottom) until there is a slight 

resistance. 

CAUTION: If the print pad is set too high, damage to the print pad or 

print jets may occur.

NOTE: If the paper can not be inserted between the print jets and 

the print pad, turn the adjustment knob clockwise (from the bottom) 

until there is a slight resistance on the paper.

5.  Select the lower middle triangle.

6.  Once the print jets have moved to the front center of the print pad, slide the 

paper between the print jets and the print pad. 

NOTE: If there is a slight resistance, proceed to step 8.

7.  If there is no resistance on the paper when sliding it between the print jets and 

the print pad, rotate the adjustment knob counter-clockwise (from the bottom) 

until there is a slight resistance.

CAUTION: If the print pad is set too high, damage to the print pad or 

print jets may occur.

NOTE: If the paper can not be inserted between the print jets and 

the print pad, turn the adjustment knob clockwise (from the bottom) 

until there is a slight resistance on the paper.

8.  Select the upper left corner of the triangle.

9.  Once the print jets have moved to the left rear of the print pad, slide the paper 

between the print jets and the print pad. 

NOTE: If there is a slight resistance, proceed to step 11.

A

B

C