3D Systems CubePro Repair Manual - page 27

26

3D Systems, Inc

.

64.  Select the lower middle triangle.

65.  Once the print jets have moved to the front center of the print pad, slide the 

paper between the print jets and the print pad. 

NOTE: If there is a slight resistance, proceed to step 67.

66.  If there is no resistance on the paper when sliding it between the print jets and 

the print pad, rotate the adjustment knob counter-clockwise (from the bottom) 

until there is a slight resistance.

CAUTION: If the print pad is set too high, damage to the print pad or 

print jets may occur.

NOTE: If the paper can not be inserted between the print jets and 

the print pad, turn the adjustment knob clockwise (from the bottom) 

until there is a slight resistance on the paper.

67.  Select the upper left corner of the triangle.

68.  Once the print jets have moved to the left rear of the print pad, slide the paper 

between the print jets and the print pad. 

NOTE: If there is a slight resistance, proceed to step 70.

69.  If there is no resistance on the paper when sliding it between the print jets and 

the print pad, rotate the adjustment knob counter-clockwise (from the bottom) 

until there is a slight resistance.

CAUTION: If the print pad is set too high, damage to the print pad or 

print jets may occur.

NOTE: If the paper can not be inserted between the print jets and 

the print pad, turn the adjustment knob clockwise (from the bottom) 

until there is a slight resistance on the paper.

70.  Once completed, select the 

checkmark

 to exit the utility.