3D Systems CubePro Repair Manual - page 30

29

3D Systems, Inc

.

Printing The Level Gap Calibration File

NOTE: Ensure the print pad is completely clean from glue and printed parts before beginning this procedure.

1.  Navigate to 

http://cubify.com/en/CubePro/Activate

. Select 

CALIBRATION 

FILES

 and extract them to your computer’s hard drive.

2.  Navigate to the file location and copy the appropriate file to your USB mass 

storage device.

NOTE: There are two Level Gap Calibration files as well as four Nozzle Offset Calibration files. The two Level 

Gap Calibration files are print material specific. Select the file based on the material cartridge type (ABS or PLA) 

installed in cartridge bay 1.

3.  Insert the USB mass storage device into the USB host port on the printer and 

select 

PRINT

.

4.  Using the arrows, navigate to the appropriate Level Gap Calibration file and 

select 

PRINT

.

5.  Apply two thin layers of Cube Glue to the print pad in an area of 50 mm x 50 

mm. Select the 

checkmark

 to continue.

NOTE: For more information, refer to the section titled 

Applying 

Cube Glue

 in the user guide.

NOTE: It may take about five (5) minutes to print the file.

6.  When finished, remove the print pad and verify the Level Gap. 

NOTE: Refer to the sections titled 

Reading The Z-Gap Calibration Print 

and

 Reading The Level Gap Calibration 

Print

.

NOTE: If adjustments are needed, perform this procedure again after making the adjustments. Make sure all glue 

and plastic residue have been removed prior to performing this procedure again.

7.  Calibrate the offset jets.

NOTE: Refer to the section 6 of this guide.