3D Systems CubePro Repair Manual - page 36

35

3D Systems, Inc

.

Offset Jets Calibration Procedure

The following procedure demonstrates calibrating print jets 1 and 2 on the X-axis. Calibrating the Y-axis is the same procedure. The 

illustration below will be used for demonstration purposes. Be sure to refer to the actual scale printed by your printer and adjust the 

settings accordingly. 

1.  Browse to 

http://cubify.com/en/CubePro/Activate

.

2.  Select 

CALIBRATION FILES

.

NOTE: The files will begin to download.

3.  Extract the files to your computer’s hard drive.

4.  Navigate to the file location and copy the appropriate Nozzle Offset Calibration 

file to your USB mass storage device.

NOTE: The Nozzle Offset Calibration files are specific for the model 

printer (CubePro Duo or CubePro Trio) and for the material type 

(ABS or PLA) currently installed in the printer.