3D Systems CubePro Repair Manual - page 26

25

3D Systems, Inc

.

60.  Navigate to the 

Print Plate Calibration

 screen and select 

LEVEL PLATE

. 

Select the 

checkmark

 to continue.

NOTE: The print pad will raise and the print jets will maneuver to the 

left rear of the printer.

61.  Select the upper right corner of the triangle on the touchscreen display.

NOTE: The printheads will move to the right rear corner of the print 

pad.

62.  Using the designated page from the Setup/Repack instructions, slide the paper 

between the print jets and the print pad.

NOTE: If there is a slight resistance, proceed to step 64.

NOTE: The red line (C) illustrates the gap between the print jets (A) 

and the print pad (B).

63.  If the paper slides easily between the print jets and print pad, rotate the 

adjustment knob counter-clockwise (from the bottom) until there is a slight 

resistance. 

CAUTION: If the print pad is set too high, damage to the print pad or 

print jets may occur.

NOTE: If the paper can not be inserted between the print jets and 

the print pad, turn the adjustment knob clockwise (from the bottom) 

until there is a slight resistance on the paper.

A

B

C