3DR Solo User Manual - page 48
43
Figure 9.4.2.1: Detaching the Antenna from the Leg
Attach the new leg by threading the antenna cable through the notch in the top of the leg (1) and securing the leg
using the provide screws (2).
Figure 9.4.2.2: Attaching a New Leg with an Existing Antenna
To secure the antenna to the new leg, use the provided Velcro to attach only the yellow-backed Velcro strip to the
Velcro on the antenna. Then remove the backing and attach the Velcro and antenna to the inside of the leg, placing
the tip of the antenna 5 mm from the edge of the rubber foot (1) as shown below. Fold the ends of a provided
plastic sheet at right angles (2), remove the adhesive backing, and stick the plastic sheet to the leg so it secures the
antenna in place (3).
Figure 9.4.2.3: Attaching an Existing Antenna to a New Leg
1
2
3
2
1
3
2
1
5 mm between
antenna and foot