3DR Solo User Manual - page 51
Other manuals for Solo:
User Manual, User Manual, Installation Instructions Manual, Operation Manual
of
57
46
Figure 9.5.3.3: Motor Pod Disconnection
Gently pull the wires about 1 inch outside of the arm to facilitate reattachment as shown in the Figure 5.2.2.A below.
Connect the 3 cables from the arm to the new motor pod. Feed the cables inside the arm and set pod into place.
Figure 9.5.3.4: Motor Pod Connection
Turn over Solo and replace the 4 screws (apply Loctite) to secure the new motor pod into place. Snap the LED cover
back into place.
Figure 9.5.3.5: Motor Pod and LED Cover Attachment
1
2