3M Accuspray Owner's Manual - page 12
11
EN
GL
IS
H
ATTENTION
Note: Do Not Put In Gun Washer.
Solvent left in the spray gun air passages could result in a
poor quality paint finish Do not use any cleaning method
which may allow solvent into the spray gun air passages
Do not expose air flow control valve and gauges to solvent
as damage may occur
Cleaning Process
1 Relieve the air and fluid pressure from the spray gun and cup before servicing
2 To retain unused paint or temporarily store mixed material, see your Local, State, Federal and OSHA guidelines, along
with paint manufacturer’s recommendations for storage
3 To flush spray gun, run water or compatible and compliant solvent into the spray gun fluid passage while triggering the
spray gun until the cleaning fluid appears clear
Note:
If feasible, clean atomizing head prior to disposal Dispose of all used atomizing heads and spray gun bodies in
accordance with federal, state and local regulations To change the atomizing head, refer to the section “Attaching the
Atomizing Head” on page 7
PDF Scaled at 100.0%