3xLogic VX-2S-CPIR-W User Manual - page 35
USER MANUAL| VX-2S-CPIR-W
10385 Westmoor Drive, Suite 210, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
35
6
Accessing the VX-2S-CPIR-W User Interface
6.1 Access UI via Web Browser
Steps:
1. Open a web browser.
2. Input the IP address of the network camera in the URL address bar, e.g., 192.0.0.64 and press the
Enter key to enter the login interface. Alternatively, if the camera is interfaced with VIGIL Client, the
web UI can be instantly deployed by right clicking the camera’s parent Site node in the VIGIL Client
treeview and selecting Server Settings.
3. Input the user name and password and click Login.
NOTE:
The default username/password is admin/12345. If the camera has already been configured
using one of 3xLOGIC’s setup tools (See Section 2 Camera Setup Options), then default credentials will
have been changed by the installer (this is a standard security precaution enforced by the setup
tools). Contact your security network administrator for credentials.
NOTE:
English is the only supported language.
Figure 6-1
Login Interface
4. To view video and have full access to the camera’s configuration settings, you will need to install the
Web Components plug-in. Click “Activate Web Components” to start the plug-in installation.
NOTE:
Depending on your web browser, you may be required to authorize the installer to run.
NOTE:
You may have to close the web browser to install the plug-in. Reopen the web browser and log in
again after installing the plug-in.