3xLogic VX-2S-CPIR-W User Manual - page 42
USER MANUAL| VX-2S-CPIR-W
10385 Westmoor Drive, Suite 210, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
42
8
Network Camera Configuration
8.1 Configuring Local Parameters
The Local Configuration settings allow the user to set the parameters for live view, recorded files and
captured pictures/stills. The recorded files and captured pictures/stillshots can be captured using the
camera’s browser UI and are saved to a destination path on your local system.
Steps:
1.
Enter the Local Configuration interface: Configuration > Local.
Figure 8-1
Local Configuration Interface
2.
Configure the following settings:
Live View Parameters:
Set the Protocol Type and Live View Performance settings.
Protocol Type: TCP, UDP, MULTICAST and HTTP are selectable.
►
TCP: Ensures complete delivery of streaming data and better video quality,
however, real-time transmission will be affected (skipped frames, etc…)
►
UDP: Provides real-time audio and video streams though video quality may be
lowered due to bandwidth limitations.
►
HTTP: Allows the same quality as TCP without setting specific ports for streaming
under some network environments.
►
MULTICAST: It’s recommended to select MCAST type when using the Multicast
function. For detailed information about Multicast, refer to
Configuring Basic Settings – Configuring TCP/IP Settings.
Play Performance: Set the play performance to Shortest Delay or Auto.
Rules: Refers to on-screen tracking for rules configured on the camera. Select enable or
disable to display or not display colored trackers when motion detection, face detection, or
intrusion detection is triggered. E.g., If face detection is enabled and this option is active,