3xLogic VX-2S-CPIR-W User Manual - page 92
USER MANUAL| VX-2S-CPIR-W
10385 Westmoor Drive, Suite 210, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
92
2.
Check Enable Video Tampering checkbox to enable the video tampering detection.
3.
Set the video tampering area. Refer to Task 1: Set the Motion Detection Area in Section 12. 1 –
Configuring Motion Detection
4.
Click Edit to edit the arming schedule for video tampering. The arming schedule configuration is
the same process as setting the arming schedule for motion detection. Refer to Task 2: Set the
Arming Schedule for Motion Detection in Section 12.1 – Configuring Motion Detection
5.
Check the checkbox to select the linkage method taken for the video tampering. Audible warning,
notify surveillance center, send email and trigger alarm output are selectable. Please refer to Task
3: Set the Linkage Method for Motion Detection in Section 12.1 – Configuring Motion Detection
6.
Click Save to save the settings.
CONFIGURING ALARM INPUT
Steps:
1.
Enter the Alarm Input Settings interface: Configuration > Event > Basic Event > Alarm Input.
2.
Choose the alarm input No. and the Alarm Type. The alarm type can be NO (Normally Open) and
NC (Normally Closed). Edit the name to set a name for the alarm input (optional).
Figure 12-8
Alarm Input Settings
3.
Click Arming Schedule to set the arming schedule for the alarm input. Refer to Task 2: Set the
Arming Schedule for Motion Detection in Section 12. 1 – Configuring Motion Detection
4.
Click Linkage Method and check the checkbox to select the linkage method taken for the alarm
input. Refer to Task 3: Set the Linkage Method for Motion Detection in Section 12.1– Configuring
Motion Detection
5.
You can copy your settings to other alarm inputs.
6.
Click Save to save the settings.