4xem WLPTZ User Manual - page 74
- 70 -
Set Server Parameter Values
Note: This request require administrator access
Method: GET/POST
Syntax:
http://<servername>/cgi-bin/admin/setparam.cgi?
[nosync=
[&
parameter value
description
nosync
0, 1
Specifies that there should be no sync (write) of
the corresponding configuration file on flash. If
parameter is omitted, a sync write will occur.
(note: this parameter must be put at begin of
parameter list)
value to assigned Assign
to the parameter
return
Redirect to the page
parameter is assigned. The
be a full URL path or relative path according the
the current path. If you omit this parameter, it
will redirect to an empty page.
(note: The return page can be a general HTML
file(.htm, .html) or a server script executable
(.vspx) file. It can not be a CGI command. It can
not have any extra parameters. This parameter
must be put at end of parameter list)
Example: Set the IP address of server to 192.168.0.123
http://myserver/cgi-bin/admin/setparam.cgi?Network_IPAddress=192.168.0.123