A-Dec 500 Installation Manual - page 10
A-dec 500 12 O’Clock Delivery System Installation Guide
10
86.0466.00 Rev E
Manual Operation
You can use the touchpad buttons to manually operate:
• Chair positions
• Cupfill
• Bowl rinse
• Dental light
• A-dec relay
• Handpiece settings
(Deluxe Touchpad only)
Chair Positions: The chair positioning buttons allow you
to manually move the chair base up/down and back
up/down.
Cupfill: The cupfill function controls water flow from
the cuspidor into a cup:
• Press the cupfill button for a timed operation.
• Press and hold the cupfill button for
manual operation.
Bowl Rinse: Bowl rinse provides rinse water for the
cuspidor bowl:
• Press the bowl rinse button for a timed operation.
• Press and hold the bowl rinse button for manual
operation.
Dental Light: The dental light button on the touchpad
functions as a three-way switch. You can turn the dental
light on or off from either the touchpad or the dental
light:
• Press the dental light button to toggle between two
intensity settings. The dental light toggles between
composite-medium intensity or composite-high
intensity settings.
When the dental light is in composite mode, the
indicator light next to the button blinks. The dental
light has an auto on/off feature. When you use a
programmed chair position (1 or 2) the dental light
turns on when the chair reaches operating position.
• Press Position 0 (entry/exit) and the dental light
automatically turns off.
Item Description
Item Description
A
Memory Setting
Indicator
G
Warning Beep Indicator
B
A/B Operator Indicator
H
Endodontics Light
Indicator
C
Attachment Ratio
Setting
J
File Torque Limit/Unit
Indicator
D
Memory Buttons
(m1—m4)
K
Forward/Reverse and
Torque Mode Indicator
E
Endodontics Mode
Toggle Button
L
Forward/Reverse
Toggle Button
F
File Speed Setting
M
Program Button
5
F
G
H
J
K
L
M
A
B
C
D
E
NOTE
If you press the bowl rinse button twice
in less than two seconds, it switches to
continuous operation mode. Press the button
once to end the continuous bowl rinse mode.
NOTE
If Position 3 has been changed to a
programmable position, the light operates the
same as for Position 1 and 2.