A-Dec 500 Installation Manual - page 5
A-dec 500 12 O’Clock Delivery System Installation Guide
86.0466.00 Rev E
5
To install the foot control on a wall:
1. Drill a 2-1/8" (54 mm) hole.
2. Install the tubing through the grommet. Push the
grommet and tubing through the wall plate.
3. Attach the cover plate to the wall. Use fasteners
provided in the wall plate kit.
Attach the Power Supply
Refer to the flow diagram. This procedure is for standard
300-watt power supplies only.
1. Splice the power supply tubing into a line with the
matching tubing.
Connect the Air Supply
1. Purge the manual shutoff valves of debris.
2. Connect the air/filter regulator to the manual air
shutoff valve.
Wire the Delivery System
1. Connect all of the data lines from the delivery
system. Use the data connector provided.
2. Connect the low-voltage power cables to the power
supply.
Install Ancillary Equipment
Install any ancillary equipment (such as a curing light,
etc.) for the A-dec 500 12 o’clock system. Use the
instructions provided with the modules.
NOTE
If you must make connections to any
configuration other than a standard 300-watt
power supply, follow the instructions
provided with that power supply. Remote
power supply cables are available to connect
the delivery system to the 511 chair. Refer to
the A-dec Equipment Catalog for more
information.
Wall Plate
Grommet
Foot Control
Tubing
Four-Way
Connection
Three-Way
Connection from
Power Supply
CAUTION
Circuit boards are sensitive to
static electricity. Electrostatic Discharge
(ESD) precautions are required when
touching a circuit board or making
connections to or from the circuit board.
Circuit boards should be installed only by an
electrician or qualified service person.