A-Dec 585 Installation Manual
A-dec 585 Wall Monitor Mount
I
N S T A L L A T I O N
G
U I D E
86.0058.00 Rev E
Recommended Tools
• 7/16" combination wrench
• Tape measure
• Socket set and ratchet with 6
"
extension
• Phillips head screwdriver
• Hole saw - 1.75
"
• Level
• 3/8
"
drill with a 3/16" drill bit
• Hex key set (“T” handles recommended)
Before You Begin
Check with local building and code
authorities about installation requirements.
They differ from state to state
and internationally.
CAUTION
Use an SJT type cable
when connecting power to the
monitor. SJT cables are more
durable than the SVT cables
typically provided by monitor
manufacturers and they are
required when routed through
moving arms.
• Do not use a monitor that weighs
more than 20 lb.
• Use a monitor that fits a 75 mm
or 100 mm VESA pattern mount.
• Always follow local building and
electrical codes.
NOTE
Not all parts included in this
kit may be necessary for your
particular installation
or configuration.
Figure 1. Wall Monitor Mount (Model 585)