A-Dec 585 Installation Manual - page 5
A-dec 585 Wall Monitor Mount Installation Guide
86.0058.00 Rev E
5
Install the Flexarm
1. Apply a light coat of Lubriplate
®
or
another lubricant to the flexarm
adaptor groove.
2. Lubricate the flexarm joint retainer.
3. Insert the flexarm in the rigid arm collar.
See Figure 10.
4. Use a 1/8" hex key to secure the joint
retainer with the two 10-32 x 5/16"
button head screws. See Figure 10.
5. Route the monitor cables down through
the flexarm knuckle. See Figure 11.
NOTE
Take note of the position
of the stop screw before
securing the flexarm. For more
details see “Change the Rotation
Stop Location” on page 8.
WARNING
Keep a firm hold on
the flexarm to prevent it from
falling while installing the
joint retainer.
Figure 8. Lubricate the Adaptor Groove
Figure 9. Lubricate the Joint Retainer
Figure 10. Insert the Flexarm in the Rigid Arm Collar
Figure 11. Route the Monitor Cables Though the Flexarm
Flexarm
Adaptor
Flexarm Adaptor Groove
Rigid Arm Collar
Joint Retainer
Flexarm
Stop Screw
Actual Size
10-32 x 5/16"
Flexarm
Rigid Arm
Monitor Cables
Knuckle