A-Dec 585 Installation Manual - Adjust The Monitor Mount
A-dec 585 Wall Monitor Mount Installation Guide
8
86.0058.00 Rev E
Adjust the Monitor Mount
Change the Rotation Stop Location
The stop screw sets the rotation limits.
There are two joint locations (monitor and
flexarm) with four stop screw positions at
each location that rotate 310
º
from
stop to stop.
To achieve the proper rotation angle of the
flexarm or monitor adaptor, you must move
the corresponding stop screw to one of the
four stop screw positions. See Figure 18.
1. Use a 1/8" hex key to remove the screws
securing the joint retainer, and then
remove it.
2. Rotate the flexarm or adaptor until the
stop screw is visible.
3. Use a Phillips head screwdriver to
remove the stop screw.
4. Rotate the flexarm or adaptor to locate a
new mounting hole location.
5. Install the stop screw.
6. Rotate the arm away from the stop
screw, and reinstall the joint retainer.
Figure 18. Monitor Mount Stop Screw Locations WIth Four
Positions at Each Location
Figure 19. Remove the Joint Retainer
Figure 20. Rotation Stop Location
Flexarm Stop
Monitor Stop
Flexarm Stop
Monitor Stop
5/32" Hex Key
Joint Retainer
Stop Screw
Hex Key