A-gear P1004T EPON Hardware Installation Manual - Access Device
1.
Access Device
This chapter mainly describes and introduces overall characteristics and parameters of
A-GEAR P1004T EPON access device so that readers can get an overall understanding about
A-GEAR P1004T EPON.
1.1.
Description of outline in standard configuration
A-GEAR P1004T EPON interface consists of the following parts: 4 100-MB RJ45 ports, 1
GEPON optical port, 1 Power port, 1 switch, 1 Reset and 1 ground point. See following table
for detailed description.
Table 1-1. Characteristics of the Ports
Port name
Description
LAN1~4
RJ45 100MB Ethernet port, link cable
GEPON optical port
SFF, link optical fibre
Power port
Link power supply
Switch switch
Control device switch
Figure 1-1. Front Panel View of A-GEAR P1004T EPON.
Table 1-2. Description of Front Panel Components of A-GEAR P1004T EPON
Component
No.
English
name
Chinese name
Description
1
LAN1~4
RJ45 Ethernet Port
100MB Ethernet port, connecting
Ethernet cable
2
PON
GEPON optical port
SFF INTERFACE, connecting optical fibre
3
RST
Reset key
Used for reset operation of the
equipment
4
POWER
Power supply port
Connecting power supply, used to
supply power for the equipment
5
SWITCH
Power switch
Switch of the control device
6
—
Ground point
Through the screw of this point, the
equipment outer casing is grounded
a-gear.net
Раge 3 of 13
A-GEAR World Wide Manufacturing
A-GEAR P1004T EPON Optical Network Unit (ONU)
datasheet