A-gear P1004T EPON Hardware Installation Manual - Installation Preparation
2.
Installation Preparation
2.1.
Precautions for use
Similar to other electronic products, quickly and frequently turning on/off power supply will
damage semi-conductor chip. When you need to re-start A-GEAR P1004T EPON, please turn
on power switch again 3~5 seconds after it is switched off.
Please do not violently impact A-GEAR P1004T EPON or drop it from a high place, which
may damage internal hardware of .EPON access device.
Please use correct external ports to connect A-GEAR P1004T EPON. Improper operation will
cause damage to internal elements of the port.
Note:
[1]
Please insert /pull off power line plug in the direction of power socket!
[2]
When the service life of the product expires, please do not discard it at will. To prevent from environmental
pollution, please dispose it according to related national laws and regulations, or send it to our company for
uniform disposal!
2.2.
Safety Suggestions
2.2.1.
Ensure safety in compliance with the following principles
•
During the course of equipment installation and after installation is completed, please
keep if dust-free and clean;
•
Place the machine in a safe place;
•
Place the tools in a place not easy to drop by touch;
•
Do no wear loose clothes to avoid being stumbled by the equipment. Tie up necktie or
scarf and scroll up sleeves.
•
If the environment may damage eyes, please wear safety goggles;
•
Do not conduct operations that may cause personal injury or damage to the equipment.
2.2.2.
Safety warnings
Safety warnings in this section refer to the warnings against personal injury that may be
caused in the case of improper operation.
•
Carefully read the installation guide, and then carry out operation on the system;
•
Only those trained, qualified personnel can install or replace EPON access
•
device;
•
Before operation on the equipment, please cut off the DC connection;
•
Final configuration of the product must comply with all applicable national laws
•
and regulations.
2.2.3.
Operation Safety Principles for Live Parts
When working on live parts, the following principles are applicable:
•
Before operation on live devices, take off jewelries (such as finger ring, necklace,
•
watch, bracelet, etc.). When metal object contacts «power» and «ground», it may
a-gear.net
Раge 6 of 13
A-GEAR P1004T EPON Optical Network Unit (ONU)
datasheet
A-GEAR World Wide Manufacturing