A-gear P1004T EPON Hardware Installation Manual - page 9
3.
Installation of A-GEAR P1004T EPON
Warning:
Only those trained, qualified personnel can install or replace the equipment.
3.1.
A-GEAR P1004T EPON Installation Flow
Start
Preparatory works
Install at specified
location
Connect the cable
Checkup
Power on
Configure
Over
3.2.
EPON access device installation
EPON access device may be placed on flat desktop or mounted on vertical wall
surface. Operation according to the steps in this section can well satisfy you
requirement for network installation. The content is divided into the following parts:
•
Install the equipment on the desktop.
•
Mount the equipment on vertical wall surface.
3.2.1.
Install the equipment on the desktop
A-GEAR P1004T EPON may be directly placed on smooth, flat and safe desktop.
Note:
Do not place too heavy object (1Kg) on the top of the EPON access device, otherwise it will be damaged.
3.2.2.
Mount the equipment on vertical wall sur face
By way of the bottom clamping slot, EPON access device may be fixed on vertical wall
surface provided with fastening screws During operation, just insert the clamping on the
back panel of the machine onto the screws. Please ensure there are at least more than two
screws and confirm their tightness.
a-gear.net
Раge 9 of 13
A-GEAR World Wide Manufacturing
A-GEAR P1004T EPON Optical Network Unit (ONU)
datasheet