AAdynTech Punch Series Light User Manual - page 10
10
•
The software shall present individually sixteen startup profiles to the user: PRESET1,
PRESET2, PRESET3, CUSTOM1 through CUSTOM12, and OFF changing the choice
each time the right or left arrow button is pressed.
•
When a profile is selected by the user, the software shall save this choice to non-volatile
memory.
•
When power is applied to light the software shall determine which stored parameters will
be recalled and put into effect. If a startup profile has be previously set it will be used to
set the parameters.
•
If the POWER ON SETTING is set to OFF the software will restore the parameters that
were automatically saved the last time the light was in operation. The parameter recalled
are:
•
LIGHT CONTROL
•
UIM BRIGHTNESS
•
UIM FADE
•
UIM EFFECT SELECTION
•
UIM EFFECT FREQUENCY
•
DMX BASE ADDRESS
•
DMX CHANNEL MODE
•
LIGHT CONTROL
•
This parameter shall support four values: “UIM”, “Wired DMX”, “Wireless DMX” and
“OFF”.
•
Selecting “UIM” shall allow the UIM button pad to control all functions of the light.
Selecting “DMX” shall allow the DMX controller to control all functions of the light.
Selecting “OFF” shall turn off the light The light shall turn on and the prior brightness
level shall be restored when “UIM” is selected again.
•
The factory default for LIGHT CONTROL is UIM (CIM/UIM control).
•
Note: In this mode, control is through either and/or both the integral CIM or
optional UIM.
•
UIM BRIGHTNESS parameter:
•
Values from 0 to 100 percent that can be incremented or decremented in steps of 0.3,
0.7 and 1.0 on slow scroll. Medium and medium fast shall scroll by one and fast shall
scroll by five.
•
Each setting value shall represent a brightness level where 0 percent is off and 100
percent is the maximum brightness of the light.
•
The change from one brightness value setting to another positive value shall be as
smooth as possible. The built in smoothing delay shall be 250ms. If the DMX controlled
brightness level is changed from a positive value to 0, the software shall turn the light off
within one half second unless UIM FADE is non-zero.
•
The factory default for the UIM BRIGHTNESS parameter shall be 100%.
•
DMX BASE ADDRESS
•
This parameter shall range between 1 and 508 for 5 CHANNELS mode.
•
This parameter shall range between 1 and 511 for 2 CHANNELS mode.
•
This parameter shall range between 1 and 512 for 1 CHANNEL mode.
•
It shall represent the DMX address on the network that is used to address the light.
•
This parameter shall be meaningful only if the light control is set to “DMX”.
•
The factory default for DMX BASE ADDRESS is 1.
•
DMX CHANNEL MODE
•
There shall be three modes of operation when the light is under DMX control. These
modes are called: 1 CHANNEL, 2 CHANNELS, and 5 CHANNELS mode. Each mode is
described in section 3.3 below.
•
The factory default for the DMX CHANNEL MODE shall be 5 CHANNELS mode.