32
2.6.2 Removing the Magazine
To remove the magazine, situate yourself as before, towards the rear
motor side of the camera. Grasp the magazine anywhere which is
comfortable at its rear. Place your hand above the motor of the ca-
mera and push the mag release lever towards the front of the camera
with your thumb. Pull the magazine straight off the camera with
your right hand.
2.7 POWER
XTRprod body requires only 12 volts for all aspects of operation.
One standard Aaton on-board (12V 3,2 ah rechargeable Nimh) will
power the camera, CCD and any accessories which are connected to
the body’s accessory inputs (such as zoom controls, speed controls
etc.) through a standard 4 pin XLR connector. One 3,2 ah on-board
battery will run 20-22 magazines on the XTRprod, without CCD
and accessories. With accessories in use, this number will decrease.