duction ID, then the camera’s equipment #, in that order.
2.10.5 ASA Setting
When using the internal lightmeter and/or AatonCode in the XTR-
prod, the ASA (ISO) setting must be adjusted to the exposure index
of the film stock being used. The ISO selector on the LCD control
panel provides settings between 25 and 1000 ASA.
With regards to the lightmeter, the setting on the ISO selector dic-
tates to the camera what the exposure should be for a particular film
stock. For AatonCode, proper ASA / ISO selection will insure that
the timecode matrix recorded on the edge of the film in the gate will
be exposed at an appropriate and useable level.
Press button Batt/Iso twice to view the ASA selection. To adjust the
ASA setting, press SET, then button Batt/Iso. Make your selection
between 25 and 1000 ISO by toggling Batt/Iso or by rotating the
jog wheel.
If the ISO selector is adjusted while the camera is in test or run po-
sition, the correction will not take place until the next camera start.
2.10.6 Battery Voltage
Press button 3 to read the voltage of the camera’s power source. No-
tice that, if the camera is running and button 3 is pressed, the
control panel will read and display the voltage under load.
2.10.7 Camera Preset Speed
The default mode of the control panel will automatically display the
camera speed selection, whether it be in sync or variable mode,
when the camera is powered but not running. When the camera is
turned on, the actual running speed to the .01 frame is displayed.
To adjust the preset speed, press SET, then button SYNC. Make
your selection of stepped crystal speed between 6 and 75 fps by tog-
gling SYNC or via the jog wheel.
2.10.8 Camera Specific Speed
To choose a specific speed press SET, then EX/VAR. Make your se-
40