Abatron BDI2000 User Manual - page 13
bdiPro
for BDI2000 (CPU16/32/32+)
User Manual
13
© Copyright 1993-2001 by ABATRON AG
V 1.12
2.5 Installation of the bdiPro Software
On the enclosed diskette you will find the bdiPro software and the firmware required for the BDI. Copy
all the files of the desired diskette to a directory on your hard disk.
The following files are on the diskette:
b20pgc32.exe
bdiPro program
b20pgc32.hlp
Helpfile for bdiPro program
b20pgc32.cnt
Help contents file
b20c32fw.xxx
Firmware for BDI2000 for CPU16/32 targets
c32jed20.xxx
JEDEC file for the BDI2000 (Rev. A/B) logic device programming
c32jed21.xxx
JEDEC file for the BDI2000 (Rev. C) logic device programming
bdiifc32.dll
BDI Interface DLL
xxxxxx.pro
Predefined Program sets
Installing BDI Pro:
• Create a new directory on your hard disk, for example C:\BDIPRO.
• Copy the entire contents of the enclosed diskette into this directory.
2.6 Configuration
Before you can use the full functionality of the bdiPro software, you must configure the system
correctly. The Setup Menu enables you to perform the following configuration tasks:
• Set the correct communication parameters
-->
Communication
between the PC and the BDI.
• Load or update the firmware / logic
-->
Firmware
• Configure the target system: memory type
-->
Target Memory
and memory organization
• Program the initialization routines for the
-->
Target Initlists
target system.
Any time you need information about specific menus and dialog boxes, you can display the
integrated Help screens by pressing the F1 function key.
The Edit and Target menus will only become active when you have specified a memory type (see
Target Memory in the Setup Menu).