Abrelex EnerSolis ES 10000 User Manual - page 15
28
6.2.13
6.2.13
6.2.13
6.2.13
Output current C supplied to the load
6.2.14
6.2.14
6.2.14
6.2.14
Output power supplied to the load
6.2.15
6.2.15
6.2.15
6.2.15
Energy in kWh supplied to the load
6.2.16
6.2.16
6.2.16
6.2.16
Inverter inner temperature (in either °F or °C) (°F
or °C display change from scroll up and scroll down )
6.2.17
6.2.17
6.2.17
6.2.17
Heat sink temperature (in either °F or °C) (°F
or °C display change from scroll up and scroll down )
S
T
U
V
W
29
6.3
6.3
6.3
6.3
Inverter status indicators
The PV inverter starts up automatically when DC power from the PV array is
greater than 250 VDC. Once the PV inverter starts, it enters into one of the
following modes:
Operation
mode
LCD
Description
Normal
The PV inverter is working normally.
Whenever the PV-array voltage is
within range (300-1,000 VDC), the PV
inverter passes power to the grid as
generated by the PV array. In normal
mode the green LED shines to
indicate that the inverter is feeding
power to the grid.
Standby
If the voltage is insufficient (250-300
VDC) the PV inverter enters into
standby mode.
Error
The internal intelligent controller
continuously monitors and adjusts the
system status. If the PV inverter
encounters unexpected conditions
such as grid problems or internal
failure, it will display relevant
information on the LCD, and the red
LED will shine.
EPO
Emergency Power Off mode. In this
mode the PV inverter does not take
any power from the grid.
Shutdown
In case of little or no sunlight the PV
inverter automatically stops running.
In this mode the PV inverter does not
take any power from the grid. The
LCD and all of the LEDs on the front
panel do not work.