Accu-Steam EG24A Installation & Operator's Manual - Electric - Accu-Steam™
Accu-Steam™ G2 Electric Installation and Operators Manual
MP5018-1702
PAGE 14
PAGE 2
MP5020-1612
ELECTRIC - ACCU-STEAM™
Installation/Operational Checklist &
Warranty Registration Form
Supply Power Electrical Readings:
Temperature & Operational Verification:
°F
Yes
No
Yes
No
Yes
No
Yes
No
I accept and submit this Installation/Operational Checklist & Warranty Registration Form as complete and accurate:
Restaurant/Facility Manager Approval:
Signature
Printed Name
Date:
Fax
AccuTemp Products, Inc
Attn: Warranty Administration
8415 North Clinton Park Dr.
Fort Wayne, IN 46825
Attn: Warranty Administration
260 469-3045
Attn: Warranty Administration
service@accutemp.net
Phase?:
Single Ø
Three Ø
Measured Supply Voltage?:
208VAC
240VAC
440VAC
480VAC
380VAC
Single Ø Measured Amps
L1
L2
Three Ø Measured Amps
L1
L2
L3
What is the customer's normal operating Thermostat temperature for the Griddle?
Note: DO NOT
use an
infrared
or
flat-top mechanical mercury
thermometer.
Using a
weighted contact temperature probe with digital thermometer
, does the
surface
temperature (°F)
match
the normal
operating
temperature (°F) set on the Thermostat?
Note:
If the
operating
temperature is
250°F
, then set the digital
thermostat
to
300°F
and verify
surface
temperature.
If the
operating temperature is 400°F, then set digital thermostat to 400°F and verify surface temperature does not exceed 396° F
on the high side of the temperature drift/cycle.
Using a 9 square-grid-pattern on the griddle surface, are the surface temperatures consistent (±5°F)?
Does the Griddle heat light cycle OFF/ON once the surface temperature has reached the set temperature?
Does the unit operate properly for 15 minutes after the griddle has reached operating temperature?