Accu-Steam EG24A Installation & Operator's Manual - Installation
Accu-Steam™ G2 Electric Installation and Operators Manual
MP5018-1702
PAGE 17
installed, adjust the four foot adjusters up or
down as needed to level the appliance side to
side and front to back.
ACCUTEMP STAND
If on an AccuTemp griddle stand with casters,
ensure that the floor surface is level and place
the two locking casters to the “on” position
and follow the leveling instructions to verify the
appliance is level.
ELECTRICAL SUPPLY
The ACCU-STEAM™ appliance has been
designed, manufactured and tested to meet or
exceed the demanding standards of safety set
forth by Underwriters Laboratories, Inc. To to
ensure that this high level of safety is maintained
in your installation, it is important that you read
and understand the following information before
attempting to plug in your griddle.
ELECTRICAL REQUIREMENTS
Electrical requirements are listed on the data
plate located on the front of the appliance. This
appliance is supplied with a 6ft (1.83m) cord and
the appropriate UL listed plug. Make sure that the
voltage at your supply receptacle is within ± 10 %
of the voltage listed on the appliance data plate.
( See Fig. 3)
Connection to any other voltage may cause
damage to components in the appliance.
The plug must be used with the appropriate
receptacle.
GROUNDING INSTRUCTIONS
Grounding provides a path for electric current
to reduce the risk of shock. This appliance is
equipped with a power cord having a grounding
conductor and a grounding plug.
ELECTRICAL CONNECTIONS
The receptacle requirements vary between
models.
• For a 240 V single-phase model, you will need
a NEMA 6-50R receptacle.
• For a 208/240V three-phase model, you will
need a NEMA 15-50R receptacle.
• For a 400V (380V-415V) 4 pole 5 wire model
you will need a IEC 60309 Device, IP44
splash proof receptacle.
• For a 440V/480V three-phase model you will
need a NEMA L16-30R receptacle.
WARNING
This appliance must be properly grounded in
accordance of all current International ,national,
state and local codes. Never remove the
ground prong of the plug.
INSTALLATION
CAUTION
Do not direct wire this appliance as it will void all warranties.
Use only the power cord and plug that is supplied with the
appliance as these are approved by Underwriters Laboratories,
Inc.