AirCard 800 Series Installation Manual - Installation On Windows Nt
Note: The AirCard modem
driver requires that Windows
Networking is installed. Also
the PC Card slots must be
enabled. If you are not certain
that networking is installed
and the slots enabled, see the
Windows NT user documen-
tation for instructions. You
must be logged in with admin-
istrative privileges.
Note: The installer runs twice—
once to install Watcher and once
to install the Network Adapter
Manager.
Software and Driver Installation
To close the CD start-up menu, click the
exit
option in the lower
right corner of the window.
Watcher should launch automatically when the AirCard
modem is inserted. If your AirCard modem has not yet been
configured to use your account, you are prompted to do so.
“Setting up a profile” on page 26
.
Installation on Windows NT
Note: You must re-install the Windows NT Service Pack after you
install the AirCard modem driver. Ensure you have your Service Pack
CD before you begin. (Version 6a is supported.)
Note: Windows Installer Redistributable 2.0 must be installed. This is
available on the Microsoft web site,
.
Note: The Performance Data Helper DLL, PDH.DLL, must be
installed. You can download this from the Microsoft web site.
Note: You may require your Windows CD. Ensure that you have the
CD before proceeding.
1.
If the AirCard modem CD is not already in your CD-ROM
drive, insert it. The CD should autostart and display a
menu.
If the CD does not autostart, select
Start > Run
and enter
d:\setup.exe
where
d
is the drive letter of your CD-ROM
drive.
2.
From the CD start-up menu, select
notebook installation
and
then the link under
notebook software installation
to launch
the installer.
3.
Use the
Next
and
Back
buttons to navigate through the
installer.
When the software installation is complete, exit the startup
menu by clicking
exit
in the lower right corner.
Rev 3.4 Apr.06
19