AirCard 800 Series Installation Manual - page 27
service provider specified an IP address, or DNS
address(es), select the
Advanced
folder. Otherwise, click
OK
and skip to
6.
Select the
Launch after connecting
field, and from the drop-
down list, select which application, if any, you want
Watcher to automatically launch when a connection is
established with this profile:
·
None
—No application is autolaunched.
·
Browser
—Watcher autolaunches your default Internet
browser.
·
MS VPN
—Watcher autolaunches a Virtual Private
Network (VPN) connection.
·
Application
—Watcher autolaunches an installed VPN
program, or any other program.
7.
Complete the appropriate field, depending on the option
you chose in the
Launch after connecting
field:
·
If you selected Browser, in the
URL
field—type the URL
for the web site you want to view on connection (such as
www.sierrawireless.com).
·
If you selected Microsoft VPN—in the
Microsoft VPN
(PPTP) connection
field, select the VPN connection from
the drop-down list.
·
If you selected Application, in the
Application
field—
enter the path to the program or use the browse button
to locate the .exe file for the software application you
want to autolaunch.
8.
If your service provider has given you an IP address, in the
Advanced
folder, click
TCP/IP
. Select
Static IP
and enter the
address in the field below. Otherwise select
Dynamic IP
.
(This is the default because most networks use dynamic IP
addressing.) Use the data compression or IP header
compression fields if supported by your service provider.
Note: The
Use IP header compression
field should NOT be used
unless your service provider is using this compression. The AirCard
modem cannot maintain a connection if this is enabled but not
supported on the network.
9.
If you have a DNS address or addresses, click
DNS Settings
and enter the address(es). (In most cases, it is not necessary
to enter a DNS address.)
10.
If you have more than one profile, select
Profiles
, and in the
Default Profile
field, choose the default profile from the
drop-down list. (The “default” profile is the one used by
the autoconnect feature and is used if you click
Connect
without selecting a profile.)
Rev 3.4 Apr.06
27