Angri-Fab LST 42 Owner's Manual - page 11

11

Hold this drawing above you while viewing the

Clutch/Idler Assembly from underneath the

tractor. Right and left in the drawing will be the

reverse of the viewer's right and left.

FIGURE 18

VIEWED FROM UNDERNEATH

FIGURE 17

6. Remove the engine pulley keeper from the side of

the tractor frame by removing the washer and nut

that secure the keeper. Attach the new pulley

keeper supplied with the snow thrower, reusing the

original bolt, washer and nut. See figure 17.

NOTE:

 Some tractors may already be equipped

with an identical pulley keeper.

7. Attach the clutch/idler assembly to the tractor frame

by sliding the notched arms at the rear of the

assembly onto the two shoulder bolts  assembled

to the inside of the tractor frame. Lift the front of

the assembly, fitting the sides into the R.H. and

L.H. hanger brackets. Attach the assembly to the

brackets using two pivot lock pins and 1/8" hairpin

cotters. See figure 17.

8. Assemble the short "V" belt onto the engine pulley

and then onto the large pulley on top of the clutch/

idler assembly. The belt must be placed to the

inside of the engine pulley keeper, the idler pulley

and the keeper bolt located beside the large pulley.

See figure 18.

IMPORTANT:

Do Not

 assemble the "V" belt

around the outside of the engine pulley keeper or

the keeper bolt.

8. Proceed to page 13.

ENGINE

PULLEY

KEEPER BOLT

IDLER

PULLEY

ENGINE

PULLEY

KEEPER

Left Side

of Tractor

PIVOT LOCK PIN

1/8" HAIRPIN COTTER

NEW ENGINE PULLEY KEEPER WITH

ORIGINAL BOLT, NUT AND WASHER