Angri-Fab LST 42 Owner's Manual - page 6
6
1. Remove all parts and hardware packages from the
carton. Lay out parts and hardware and identify using
the illustrations on pages 4 and 5.
NOTE:
Not all of the supplied parts and hardware will be
needed for your particular tractor. Unneeded items
may be discarded after you have completed assem-
bly.
REMOVAL OF PARTS FROM CARTON
(2)
7/16" Wrenches
(2)
1/2" Wrenches
(2)
9/16" Wrenches
(2)
3/4" Wrenches
(1)
Knife
ADDITIONAL ITEMS REQUIRED
General Purpose Grease
TOOLS REQUIRED FOR ASSEMBLY
ITEMS REMOVED FROM TRACTOR
1. Store all tractor parts that you remove and do not
need to re-use to assemble the snow thrower.
TRACTOR PREPARATION
Before performing these instructions, refer to the Service
and Adjustments section of your tractor owner's manual
for specific safety instructions.
1. Allow engine, muffler and exhaust deflector to cool
before beginning.
2. Remove any front or rear attachment which is
mounted to your tractor.
3. Remove the mower deck. Refer to your tractor
owner's manual for removal instructions. Mark all
loose parts and save for re-assembly.
4. Remove the tractor hood and grill assembly. Refer to
your tractor owner's manual for removal instructions.
CAUTION
:
Before starting
to
assemble
the snow thrower, remove the spark plug
wire(s), set the parking brake and
remove the key from the tractor ignition.
ASSEMBLY OF SIDE PLATES TO TRACTOR
Right hand (R.H.) and left hand (L.H.) side of the tractor
are determined from the operators position while seated
on the tractor.
TRACTORS WITH FRAME MOUNTED FRONT
SUSPENSION BRACKETS
(See page 7 for tractors
with axle mounted front suspension brackets.)
1. Remove two bolts from each side of the tractor
frame as shown in figure 1.
2. If there is a third bolt on the right side, as shown in
figure 1, remove the nut and washer from the bolt.
FIGURE 1
RIGHT SIDE VIEW
3. Assemble the R.H. Side Plate (marked "R") to the
now empty holes in the right side of the tractor frame.
Use two 3/8" x 1" hex bolts and 3/8" lock washers as
shown in figure 2. Repeat for the L.H. side.
4. Assemble the whizlock nut onto the third bolt (if
present) on the right side of the tractor.
NOTE:
Be sure to reassemble all bolts and nuts
to tractor frame if you remove the side plates.
FIGURE 2
RIGHT SIDE VIEW
3/8" x 1"
HEX BOLT
3/8" LOCK
WASHER
R.H. SIDE
PLATE
5/16" WHIZLOCK NUT
(IF BOLT IS PRESENT IN TRACTOR)
REMOVE BOLTS
FROM THESE HOLES
FRONT
SUSPENSION
BRACKET
REMOVE NUT & WASHER
AND LEAVE BOLT (IF PRESENT)