Angri-Fab LST 42 Owner's Manual - page 7
7
2. Attach the R.H. Side Plate (marked "R") to the right
side of the tractor frame. For the front hole use a 3/8"
x 1" hex bolt, a 3/8" lock washer, a 1/2" flat washer
and a 3/8" hex lock nut. Use the flat washer as a shim
between the frame and the side plate. For the rear
hole use a 3/8" x 1" hex bolt, and a 3/8" lock washer.
See figure 5. Repeat for the L.H. side.
NOTE:
The bolts will cut threads into the front holes
if that is required.
NOTE:
If the side plates are removed from the
tractor frame, bolts must be assembled back into
the empty holes in the frame.
5. Assemble a shoulder bolt, a 3/8" lock washer and a
3/8" hex lock nut to the bottom hole in each side
plate. See figure 3.
6. Proceed to page 8.
3. Assemble a shoulder bolt, a 3/8" lock washer and a
3/8" hex lock nut to the bottom hole in each side
plate. See figure 6.
FIGURE 5
RIGHT SIDE VIEW
FIGURE 6
RIGHT SIDE VIEW
FIGURE 4
RIGHT SIDE VIEW
FIGURE 3
RIGHT SIDE VIEW
TRACTORS WITH AXLE MOUNTED FRONT
SUSPENSION BRACKETS
1. Remove the bolt from the hole on each side of the
tractor frame as shown in figure 4.
3/8" SHOULDER BOLT
3/8" HEX LOCK NUT
R. H. SIDE PLATE
3/8" LOCK
WASHER
3/8" LOCK
WASHER
R.H. SIDE
PLATE
1/2" FLAT
WASHER
3/8" x 1"
HEX BOLT
3/8" HEX
LOCK NUT
3/8" SHOULDER BOLT
3/8" HEX LOCK NUT
R. H. SIDE PLATE
3/8" LOCK
WASHER
REMOVE BOLT FROM
THIS HOLE
FRONT
SUSPENSION
BRACKET