Angri-Fab LST 42 Owner's Manual - page 13
13
ASSEMBLY OF THE SNOW THROWER
1. Place the lift handle into the lift bracket on the right
side of the snow thrower. Fasten the handle to the
bracket using two 5/16" x 1-3/4" hex bolts, 5/16"
lock washers and 5/16" hex nuts. See figure 23.
FIGURE 24
RIGHT SIDE VIEW
FIGURE 23
RIGHT SIDE VIEW
6. Assemble the short "V" belt onto the engine pulley
and then onto the large pulley on top of the clutch/
idler assembly. The belt must be placed to the
inside of the engine pulley keeper, the idler pulley
and the keeper bolt located beside the large pulley.
See figure 22.
7. Place tension on the belt by pulling the left side
tensioning chain out as far as the 5/64" hairpin
cotter will allow. Secure the chain in this position by
inserting a 1/8" hairpin cotter through the chain.
See figure 22.
IMPORTANT:
Do Not
assemble the "V" belt around
the outside of the engine pulley keeper or the
keeper bolt.
Hold this drawing above you while viewing the
Clutch/Idler Assembly from underneath the
tractor. Right and left in the drawing will be the
reverse of the viewer's right and left.
FIGURE 22
VIEWED FROM UNDERNEATH
NOTE:
Be sure the lift release cable's plastic covering
remains inserted into the trigger assembly while
performing the next step.
2. Push the lift handle down into the locked position.
Insert the end of the cable wire into the hole in the
lift rod. Place the threaded fitting into the slot in the
lift bracket, with one hex nut above and one hex
nut and the lock washer below the slot. Tighten the
nuts, adjusting them to eliminate slack in the cable
wire. See figure 24. Refer also to the Service and
Adjustments section on page 20 in this manual.
HINT:
For easier assembly of the lift release cable,
tilt the snow thrower forward onto the spiral auger.
1/8" HAIRPIN
COTTER
ENGINE
PULLEY
ENGINE
PULLEY
Left Side
of Tractor
ENGINE
PULLEY
KEEPER
KEEPER
BOLT
IDLER
PULLEY
LIFT RELEASE
CABLE
HEX NUT
LOCK
WASHER
HEX NUT
CABLE
WIRE
LIFT
ROD
TRIGGER
ASSEMBLY