Angri-Fab LST 42 Owner's Manual - page 12

12

FIGURE  20

VIEW OF BOTTOM

5. Attach the clutch/idler assembly to the tractor frame

by sliding the notched rear arms of the assembly

onto the two shoulder bolts placed on the inside of

the tractor frame. Lift the front of the assembly so

that the sides fit inside the R.H. and L.H. hanger

brackets. Attach the assembly to the brackets

using two pivot lock pins and 1/8" hairpin cotters.

See figure 21.

ELECTRIC ATTACHMENT CLUTCHES

1. Turn the clutch/idler assembly upside down and

place the extra tensioning chain through the left

front hole as shown in figure 19.

FIGURE  19

FIGURE 21

RIGHT SIDE VIEW

2. Hook the loose spring through the end of the

tensioning chain. See figure 20.

3. Hook the other end of the spring onto the bottom of

the bolt and nut which secure the idler pulley to the

upper idler arm. Hold the bolt head and assemble a

3/8" hex lock nut onto the bolt, leaving it loose

enough for the spring to pivot freely between the

two nuts. See figure 20.

4. Attach a 3/32" hairpin cotter to the chain, placing it

in the fifth link from the spring. See figure 20.

CHAIN

(L.H. SIDE)

3/32" HAIR

COTTER PIN 

5TH LINK

LEFT

SIDE

3/8" HEX

LOCK NUT

SPRING

RIGHT

SIDE

TENSIONING CHAIN

PIVOT LOCK PIN

1/8" HAIRPIN COTTER