Anhui Liyu Computer Equipment Manufacturing TC Series User Manual - page 17
User’s Manual of TC Series Cutting Plotter
Test function: Under the static screen, press SELECT key to select “TEST” function, then
press ENTER key, the machine will plot self-check graph.
Light:ON OFF:
When the cursor in the “ON”, press ENTER key can choose the
Light ON or OFF, the LCD does not quit this interface and displays:
SPD:6 PRS:8
ORIGIN CURRENT ON
3-3 Operation skills
1 Loading the paper
1. Lift the pinch-roller handle and let it away from the roller.
2. Insert the paper between the roller and the pinch-roller of the machine from
behind to front.
3. Align the front of the paper basically with the board-crack of the machine, then
press down the right pinch-roller. Align the left of the paper with one of signal
lines, then press down the left pinch-roller.
Note: Different size of the machine has different quantity of pinch-roller. Each
pinch-roller can moves freely on the track. When move the pinch-roller, the
pinch-roller handle must be lifted and can only move it left or right with the
backside. Never pull the front side of the pinch-roller! Otherwise, the
precision of the machine should be damaged.
2 Pressure regulation
The pressure of the cutting plotter can be regulated by “←”or “→” key on the
controlling-panel. If the pressure is too low, the knifepoint can not cut in the plastic film, the
pattern can not be cut. On the other side, the pressure is too high can make the pattern
distortion and cut off the back paper.
17