Anhui Liyu Computer Equipment Manufacturing TC Series User Manual - page 6
User’s Manual of TC Series Cutting Plotter
2-4 Cutter/Plotter
1 Structure of cutter holder and items of components
Rotate the cutter holder to adjust the out-stretching length of the cutter as to ensure that it
doesn’t cut off the bottom layer of stickness (consists of upper and bottom layer).
1. Cutter-exiting staff
2. Cutter holder body
3. Locking-screw
4. Cutter holder shell
5. Blade or cutter (diameter is 2mm)
2 Installation and adjustment
1. Before installing the blade, you must carefully clean the cutter holder body, the
blade and your hands. Even very slight dirt powder can affect the rotating
sensitivity. Insert the blade into the cutter holder body with care, then push the
blade to the bottom with a flexile plastic or rubber, but don’t damage the blade
tip.
2. Rotate the shell of the cutter holder and make the out-stretching length of the
blade tip not larger than the thickness of the stickness.
3 Plotter holder
You can use the cheap ball-pen to plot with the given plotter holder.
1. Loose the screw on the holder with a screwdriver anti-clockwise.
2. Insert a ball-pen and let the refill tip out of proper length.
3. Clockwise fasten the screw.
4 Installation
1. Turn off the power.
2. Loose the locking-screw of the cutter-bracket, then put the cutter holder or
plotter holder in the “V” breach and ensure the blade tip or refill to reach to the
plastic pressing-strip. Fasten the locking-screw clockwise at last.
3. After turning on the machine, the tip should be raised about 1 to 2mm away
from pressing-strip.
6