Anhui Liyu Computer Equipment Manufacturing TC Series User Manual - page 20
User’s Manual of TC Series Cutting Plotter
knifepoint will pick the film and cause the waster.
2. Suggest using the compensation function for best effect when cutting the
small pattern. The angle compensation should be set between 0.3mm to
0.5mm according to the fact.
3. The knifepoint should be shorter than normal length for cutting a more
smooth small pattern.
Question 5: What shall I pay attention to the large cutting?
Answer: 1. The cutting system can split the pattern larger than the maximum cutting size
automatically. You can also split it manually. Then you can patch the parts up
a large pattern. But you should set the width of the output equal to the paper.
2. Regulate the speed to highest and disable the angle compensation and
select the non-aperture patch for the large pattern.
Question 6: What shall I do if I can’t lift up the cut pattern?
Answer: 1. Before cutting, regulate the length of knifepoint and the pressure, run the test
function for a satisfactory effect.
2. If a broken line appeared, maybe the knifepoint is wearing. Replace a new
cutter or grind the knifepoint with a small leather.
3. If the cut pattern can be lifted up in one side but can not be lifted in the other
side, maybe the length of knifepoint is inapposite or the bottom layer is not
smooth and is damaged.
Question 7: What shall I pay attention to the long cutting(1-5m)?
Answer: 1. Before cutting, a test running of the paper in the “LOCAL” state is suggested.
2. Aim the both side of the paper at the rulers in front and rear of the cutting
plotter, then press down the pinch-rollers.
3. Run the paper a distance same as the length of the long pattern by press
“↓” key in the “LOCAL” state.
4. Select “LOCAL” then press ENTER key, the paper will return to the original
point, then you can cut.
Note: Suggest cutting the long pattern partly if allowed.
20