Read and save these insturctions 2008 antari lighting & effects ltd. Dng-200 low fog generator user manual dng-200 低煙機使用說明書.
User manual antari dng-200 low fog generator congratulations on the purchase of your new antari dng-200 low fog generator thank you for choosing this dng-200 of antari! There are some new terrific features of this machine on top of the fog cooling provided by the dng-100 originally. The fog generato...
2. Unpacking & inspection open the shipping carton and verify that all equipment necessary to operate the system has arrived intact. The shipping carton should contain the following items: 1. One unit dng-200 machine 2. One unit of d-20 lcd controller (installed in the machine already) 3. Two power ...
3-3. Connecting the machine with the black fog conducting hose, it is a three-meter pipe. The actual length of the pipe can be adjusted to fit the actual need. (refer to the figure 4) 3-4. Fill antari flr light fog fluid to the tank, tighten the tank cap. (refer to the figure5) 4. Operation 4-1. Con...
5-1. Function button 5-1-1. Setting of fog output interval: press the function button once, the screen will display “interval set”. Under the time counting mode of the timer , press up/down keys to adjust the interval of fog output. The setting range is between 10 to 300 seconds. 5-1-2. Setting of f...
6. Other important notes 6-1. A water collection tray is equipped at the rear of dng-200, when the compressor is running for condensed fog, some water drops will flow into the tray. Please check if the water in the tray is full and drain it routinely.(refer to the figure 6) if the machine is to be u...
7. Maintenance of the machine 7-1. Please routinely clean your dng-200 low fog generator, it will effectively help you to lower the parts replacing rate or maintenance cost. 7-2. Please do not contaminate fog oil, put the cap on the oil tank at all time and the cap of the fog oil tank equipped on th...
Antari dng-200 built-in dmx 512 setting dng-200 is featured with built-in dmx 512 function and equipped with a 3-pin and a 5-pin male-female connectors. When the machine is in use, either 3-pin or 5-pin connector can be selected to connect to dmx controller. Dng-200 only uses one control channel, th...
