Antari DNG-200 User Manual - page 4
3-3. Connecting the machine with the black fog conducting hose, it is a three-meter pipe. The actual
length of the pipe can be adjusted to fit the actual need. (refer to the figure 4)
3-4. Fill Antari FLR light fog fluid to the tank, tighten the tank cap. (refer to the figure5)
4. Operation
4-1. Connect the power cord to a grounded outlet, press down two sets of power switches located at
the back side of the machine.
Please press power switch of compressor below first and then
power switch of fog machine to start warming up. The LCD screen on the D-20 controller will
show “Warming up”. Please wait till the LCD screen shows “Ready To Fog “.
4-2. Set all required output modes on the controller. Please refer to D-20 controller operation
description.
4-3. DNG-200 is equipped with DMX 512 system, a 3-pin and a 5-pin DMX connectors are located at
the back panel of the machine for optional use. Please refer to DMX operation description for more
DMX information.
4-4. For the first time operation, after the warming up period and the controller screen displays “Ready
To Fog”, press down Manual button for a few seconds to initiate the machine to output fog in order
to drain out the air in the liquid pipe. Once the fog comes out smoothly, D-20 controller can be set.
If the machine is not frequently used, please follow this procedure every time it is used to drain out
the air.
4-5. The heater average temperature of DNG-200 is 220°C.
5. D-20 LCD screen controller
D-20 controller is equipped with a 2-meter line, a 5-pin XLR connector and a LCD display panel. It is
able to fully display the operation status of the machine. Its interface allows the operator to customize fog
machine functions by adjusting fogging duration, interval, volume and DMX. The controller can be easily
used by pushing six function buttons on the panel. Its LCD displays current operating parameters, which
are automatically stores in non-volatile memory, allowing the machine to be powered down without losing
function settings.
Controller panel and function button description: (refer to figure)
◄Figure 4
◄ Figure 5
DNG-200
User Manual
03