Antari DNG-200 User Manual - page 8
Antari DNG-200 Built-in DMX 512 Setting
DNG-200 is featured with built-in DMX 512 function and equipped with a 3-pin and a 5-pin male-female
connectors. When the machine is in use, either 3-pin or 5-pin connector can be selected to connect to DMX
controller. DNG-200 only uses one control channel, the output value of each channel is between 0-255.
After DMX-200 controller is connected, the time of action, volume of fog output and interval of fog output are
all controlled by DMX controller, they will not be controlled by D-20 of the machine anymore.
By using the same DMX system you are able to easily connecting fog generators, lighting and other special
effect machine to have a whole system performance.
If the value is set between 0-31, then the machine is not able to have sufficient output volume to run.
If the value is set between 32 to 126, then the machine is able to output a minimum output volume 35%.
If the value is set between 127 to 191, then the machine is able to output a median output volume 35%.
If the value is set between 191 to 255, then the machine is able to output a maximum output volume 60%.
Please save this user manual carefully
192-255 = High Volume ( 60 % Output )
127 – 191 = Medium Volume ( 52% Output )
32 – 126 = Low Volume ( 35% Output )
0 - 31 = Off
High Volume
192-255
Medium Volume
127-191
Low Volume
32-126
Off
0-31
DNG-200
User Manual
07