Antari W-515 User Manual - page 4
Before beginning your initial setup on ANTARI W-515 & W-530 Fog Machine,
make sure that there is no evident damage caused by transportation. In the
event that the unit's housing or cable is damaged, do not plug it in and do not
attempt to use it until after contacting your ANTARI dealer for assistance.
Remove all packing materials from shipping box. Check that all foam and
plastic padding is removed, especially in the nozzle area.
Place fog machine on a flat surface and remove fog liquid tank cap.
Place the liquid tube into a properly filled liquid tank.
Fill with high-quality, water-based fog liquid recommended by ANTARI dealer.
The W-515 & W-530 only works with uncontaminated Antari FLR or FLG Fog
Liquid. Any other types of liquid can damage the unit resulting in spitting and
serious clogging problem. When filled, place cap back on liquid tank. Be
careful not to exceed the maximum fluid level. DO NOT OVERFILL.
There are total 6 buttons on the control panel of Antari W-515/W-530. They are
,
,
,
,
, and
respectively. User can
adjust the desired settings in the sub-menus as followings:
When the heat-up process is completed, the LCD (Liquid Crystal Display)
screen shows “Ready To Fog W” (* “
” means the machine is under wireless
control mode.)
1. When LCD displays “Ready To Fog”, press
button once, the
LCD screen shows
. Under this status, user can adjust the
fog output interval of Timer mode (the range is between 1 and 200
seconds) by
/
buttons.
2. When LCD displays “Ready To Fog”, press
button twice, the
LCD screen shows
. Under this status, user can adjust the
fog output duration of Timer mode (the range is between 1 and 200
seconds) by
/
buttons.
3. When LCD displays “Ready To Fog”, press
three times, the
LCD screen shows
. Under this status, user can adjust the fog
Setup
Operation
Control Panel Instruction
Function Timer Up Down Volume
Manual
W
FUNCTION
INTERVAL SET
UP
DOWN
FUNCTION
DURATION SET
UP
DOWN
FUNCTION
TIMER OUT
FUNCTION
VOLUME
TIMER
MANUAL