Antari W-515 User Manual - page 5
output volume of Timer mode (the range is between 1% and 100%) by
/
buttons. User can trigger Timer mode when LCD shows “Ready
To Fog” and press
button and when machine is working under Timer
mode, pressing
button again can end Timer mode.
There is a Non-Stop Burst function between Timer Out 1% and
Timer Out 100%. Choosing this function can make machine generate
continuous fog output under Timer mode.
4. When LCD displays “Ready To Fog”, press
four times, the LCD
screen shows
VOLUME OUT . Under this status, user can adjust the fog
output volume of Volume mode (the range is between 1% and 100%) by
/
buttons. User can trigger Volume mode when LCD shows
“Ready To Fog” and press
button and when machine is working
under Volume mode, pressing
button again can end Volume
mode.
There is a Non-Stop Burst function between Volume Out 1% and
Volume Out 100%. Choosing this function can make machine generate
continuous fog output under Volume mode.
5. When LCD displays “Ready To Fog”, press
five times, the LCD
screen shows
. Under this status, user can adjust the DMX
address by
/
buttons.
6. When LCD displays “Ready To Fog”, press
six times, the LCD
screen shows Wireless On. Under this status, pressing either
or
button once can switch off the wireless function. On the other hand, when
the LCD shows Wireless Off, pressing either
or
button once can
switch on the wireless function.
7. When LCD displays “Ready To Fog”, keeping pressing
button can
force machine generate 100% full fog output. As soon as releasing
button, machine stops fogging immediately.
8. There is an “Optoelectronics Fluid Sensor” inside the W-515/W-530 Thus,
when the fluid tank is empty, the pump will be cut off automatically.
At this time, the LCD screen will show “Empty Fluid”.
Please add sufficient fog fluids into fluid tank and then keep pressing
button until the “Empty Fluid” is relieved (dis-alarmed) on the
LCD screen.
9. On W-515 and W-530, if the fluid sensor is not needed, user can switch it
off. When LCD displays “Ready To Fog”, press
seven times,
the LCD screen shows Fluid Sensor On . Under this status, pressing
either
or
button once can switch off the fluid sensor. On the
other hand, when the LCD shows Fluid Sensor Off , pressing either
or
button once can switch on the fluid sensor.
10 When the heating process of the fog machine is completed and ready to
fog, the status of wireless function and fluid sensor on the LCD screen are
as followings:
UP
DOWN
Timer
Timer
Note:
FUNCTION
UP
DOWN
Volume
Volume
Note:
FUNCTION
DMX 512 ADD
UP
DOWN
FUNCTION
UP
DOWN
UP
DOWN
Manual
Manual
Manual
FUNCTION
UP
DOWN
UP
DOWN
“
”
“
”
“
”