AU Tool AVT-3190HD Instruction Manual - page 7
7
The Four buttons with the arrows are used to position and pan the image. The
Aspect button allows switching between wide screen and standard display
modes and the Overscan button allows magnification of the image.
AVT-3190HD Rear Panel
The inputs and outputs on the rear panel are clearly marked. Connect the
appropriate cables to the inputs making certain that the cables are in good
condition and undamaged. The power switch (Upper right on the drawing above)
removes or applies power to the unit. If the switch is in “Off” position, the power
switch on the front will have no effect since it is a Standby switch, not an actual
power switch. The Switch next to the power connector is used to switch between
PC input and HDTV input.
5.0
Operating the AVT-3190HD
Operating the AVT-3190HD is intuitive and easily learned. The operation at the
unit itself is accomplished via buttons mounted within the case. Although easily
learned, controlling the unit via these buttons is a rather limited way to operate
the unit because all functions are not available from these buttons.
Since virtually all users will operate the unit via the remote control to gain
complete control over its functions, it is recommended that you take the time to
discover where the various buttons are located on the remote by looking at the
actual remote and comparing it to the diagram above.
Like the manual controls on the unit, the labeling is clear for the majority of the
functions and the unit’s On Screen Display (OSD) will help clarify any confusion.
The pages that follow will magnify the remote’s control sections and explain each
function. Study the overall drawing and become familiar with the general layout of
the remote control. Refer to the descriptions that follow in this manual for detailed
information.