BabyLove BL4300/2010 Instruction Book - page 14
27
26
HOW TO USE WITH A CHILD HARNESS
HOW TO USE WITH A CHILD HARNESS
F. Engage the seat belt tongue to the buckle
and adjust the seat belt to sit firmly around
the child’s hips and thighs. The seat belt
buckle should be located as low as possible
below the child’s hip. If using a lap-sash
seatbelt and Gated Slide you will need to
adjust it so that the seatbelt is firm on the
child’s thighs and the Gated Slide is close to
the Child but not touching the child.
G. Then adjust the Protecta PLUS™ Harness
by pulling the adjuster strap (3) to remove
all slack in the shoulder straps. Do not over
tighten so as to cause the seatbelt to lift off
the child’s thighs. As the child grows this
front adjuster will need to be adjusted.
The Gated Slide needs to
be close to the child but not
touching the child. If armrests
are included the Gated Slide
needs to be under the armrest.
Converted
lap-sash
seat belt.
Converted
lap-sash
seat belt.
Slide the Gated
Slide so that it
is close to the
child but not
touching the
child.
Harness
strap
loops.
Child Harness Guide
(if provided)
Harness
strap
loops.
DO NOT LEAVE CHILDREN
UNATTENDED IN THE CAR.
:
Lap belt or
converted
lap-sash
seat belt.
USING LAP SASH SEATBELT
Thread the converted lap-sash seat belt
through the harness strap loops as shown.
Tighten the converted Lap belt over the
child's hips and thighs then remove the
slack from the Child Harness so that the
Lap belt is not lifted off the thighs.
USING LAP ONLY SEATBELT
Thread the lap seat belt through either
the Upper Harness Strap Loops or Lower
Harness Strap Loops.
Tighten the Lap belt over the child's hips
and thighs then remove the slack from the
Child Harness so that the Lap belt is not
lifted off the thighs.
Fold up excess
strap and store
with the storage
strap and close
cover.
Adjuster Cover
Storage Strap
H. Finally, roll up the excess adjuster strap,
secure using the storage strap, then close
the adjuster cover.
Child Harness Guide
(if provided)
Cross Strap