BABYSTYLE OYSTER Instruction Manual - page 4
4
PRIMARY FEATURES
FLIP OUT CANOPY
The front section of the hood can be flipped out or folded back into the
main part of the hood depending choice. To flip out the canopy hold
the front part of the canopy and pull forwards. To fold the canopy
away push it back into the hood and smooth the fabric.
ZIPPERED CANOPY EXTENSION
To maximise the hood coverage there is a zippered section in the
middle of the hood. Unfasten the zip and extend the hood. Fasten
the zip to reduce the hood coverage.
INSECT/UV NET
Concealed by a zip in the front flip-out part of the canopy is an insect
net. Unfasten the zip and unfurl the insect net. The elasticated part
of the insect net attaches around the leg rest and there are two Velcro
tabs on the side of the net which fasten to the sides of the hood. To
stow the insect net; roll neatly and place in the zippered opening
before closing the zip, being careful not to catch the net in the zip.
FITTING THE SEAT UNIT APRON
Place the bottom part of the apron over the leg rest. The press-studs
at the side of the apron allow the apron to be fastened around the
bumper bar. Pass the top of the apron under the bumper bar and
fasten the press-studs at the top of the apron to the corresponding
press-studs on the side of the seat backrest. To remove the apron,
release the press-studs and take away.
FITTING THE FOOTMUFF
FITTING AND REMOVING THE FRONT WHEELS
The footmuff top cover can be removed by unfastening the zip. The
back part of the footmuff can be used as a seat liner without the top
part.
Push in the front wheel quick release button on the front wheel
housing and push the wheel unit onto the front wheel axle stub until it
stops. Release the quick release button and check that the wheel is
locked on. To remove the wheel; push in the front wheel quick
release button on the front wheel housing and pull the wheel unit from
the axle stub.
NOTE, the axle stubs can become greasy and may leave
marks on other surfaces they come into contact with. To prevent
marking clean the axle stubs with a cloth.
To attach the footmuff to the seat unit: Release the harness clips
from the centre buckle and release the shoulder straps from the waist
belts at the buckle connection. Pass the shoulder straps and waist
belts through the corresponding openings in the footmuff. Pass the
crotch strap through the opening in the footmuff. Attach the two
press-studs at the rear top of the seat backrest to the two press-studs
on the top of the footmuff.
To keep the front wheels swivelling freely ensure they are
regularly lubricated, if steering becomes stiff, remove front wheel
units, clean, lubricate and refit.
13